Welch-allyn LC101 CO2 Module - User Manual Manual de usuario descargar pdf (Pagina 88)

LC101 CO

Module OEM Implementation Manual

Page 88 Conﬁdential Welch Allyn OEM Technologies

Conﬁgure\ Display\CO2 Scale - The CO

waveform scale can be changed in the

Conﬁgure\Display\CO2 Scale menu item. The selections are listed below.

Conﬁgure\ Display\Gridlines - Horizontal gridlines on the waveform graph can be enabled by

checking the Gridlines menu item.

Conﬁgure\ Display\Waveform Fill - The Waveform Fill feature can be enabled by checking the

Waveform Fill menu item.

Conﬁgure\CO2 Module\Flow Rate - The CO

Module’s aspiration rate can be conﬁgured with

the Flow Rate menu item. The units are in milliliters per minute.

Conﬁgure\CO2 Module\CommPort - This menu item opens the following communications port

conﬁguration screen.

NOTE The CO

Module supplied with the Evaluation System will be pre conﬁgured to match the PC

software’s default settings (Data Bits and Baud Rate), which are shown

above. The CommPort

Assignment must be set to match the PC’s CommPort connected to the CO

Module during

initial setup.

The Help\About menu item displays the software title and version, copyright and a disclaimer.

The Help\Content menu item displays help information.

50 mmHg 6%

75 mmHg 10%

100 mmHg 14%

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 97 98

Sin comentarios

Welch-allyn LC101 CO2 Module - User Manual Manual de usuario Pagina 88