Welch-allyn Solarc Light Source - User Manual Manual de usuario descargar pdf (Pagina 16)

14 Chapter 3 Maintenance Welch Allyn Light Source

2. Remove the five screws from the Solarc Light Source using a

#2 philips head screwdriver. Pivot the cover to expose the

lamp.

Figure 2. Moving the Top Cover

3. Flip up the retaining latch. Pull the lamp base back and up

against the retaining spring to remove the lamp.

4. Remove the lamp, with harness attached and then disconnect

the lamp connector.

Figure 3. Inside the Light Source

5. Replace with Welch Allyn replacement lamp 09500-U only.

DO NOT touch the lamp or the interior reflective surface of

the lamp. Skin oils on the lamp will cause premature lamp

failure. Only hold the outside of the reflector or the base of

the lamp. Remove any grease or fingerprints with a clean

Removable Screws (two on opposite side)

Pivot

Retaining Latch

Retaining Spring

Lamp Base

Lamp Connector

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 239 240

Sin comentarios

Welch-allyn Solarc Light Source - User Manual Manual de usuario Pagina 16