Welch Allyn SureTemp Plus REF 692 Especificaciones descargar pdf (Pagina 22)

18 Welch Allyn SureTemp Plus

CLEANING AND DESINFECTION

Clean and disinfect on a routine basis according to each facility's policy or whenever

contamination occurs.

CLEANING AND DISINFECTING THE THERMOMETER AND PROBE

Wipe the thermometer and probe with an appropriate health care low- or intermediate-

level cleaner/disinfecting wipe that incorporates either a 1:10 sodium hypochlorite (bleach)

solution or isopropyl alcohol as the active disinfection ingredient. Follow wipe

manufacturer's instructions for appropriate use, contact times and applicable warnings

and precautions.

CLEANING AND DISINFECTING THE REMOVABLE PROBE WELL

• Remove the probe well from the unit. Unplug the latching probe connector to prevent

the device from consuming battery power while you are cleaning the probe well.

• Clean the inner surface of the probe well by swabbing the surface with a cloth

dampened with a 1:10 sodium hypochlorite (bleach) solution or isopropyl alcohol

solution as the active disinfection ingredient. Clean the probe well's outer surface by

swabbing or wiping the surface with one of the solutions mentioned above.

• Thoroughly dry all surfaces before re-assembling the instrument.

• Re-connect the latching probe connector to the thermometer. Ensure that the

connector snaps into place.

• Re-install the probe well in the thermometer and snap the probe well into place.

• Insert the probe into the probe well.

DISPOSAL

DISPOSING OF EQUIPMENT

This equipment contains no hazardous materials. Discard without environmental risk.

Remove the batteries before disposal.

DISPOSING OF BATTERIES

Dispose of used batteries properly. Consult your local recycling authority for proper

procedures.

Caution DO NOT immerse or soak the thermometer or probe in any type of

fluid.

Caution DO NOT use steam, heat, or gas sterilization on the thermometer or

probe.

Caution DO NOT autoclave the thermometer or the probe.

Caution DO NOT use hard or sharp objects to clean the probe well. This could

damage the probe well and cause the unit to not function properly.

Caution DO NOT use steam, heat, or gas sterilization on the probe well.

Caution DO NOT autoclave the probe well.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Welch Allyn SureTemp Plus REF 692 Especificaciones Pagina 22