Welch-allyn 9600 Plus Calibration Tester - User Manual Manual de usuario descargar pdf (Pagina 18)

12 Chapter 3 Operation Welch Allyn 9600 Plus Calibration Tester

Figure 3. Power Adapter and Mains Plug Inserts

For the setup:

1. Choose the proper mains plug insert and slide it over the two

prongs in the power converter (Figure 3).

2. Plug the power adapter into the 9600 Plus Calibration Tester

(Figure 2) and the opposite end into a wall outlet.

3. Observe the Set Point Mode in the upper left hand corner of

the LCD display (Figure 1). If the unit displays a "D", it is in

Default Mode and will heat to the lowest Set Point

Temperature. If you do not want to conduct testing at this Set

Point Temperature, press and hold the Temperature Selection

button to select the desired setting. The temperature display

will flash before staying on continuously to indicate the 9600

Plus Calibration Tester has stabilized and is ready for use.

UKUS EUAUS

Two prongs in the

power adapter

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 105 106

Sin comentarios

Welch-allyn 9600 Plus Calibration Tester - User Manual Manual de usuario Pagina 18