Welch Allyn SCANTEAM 5770 LASER Especificaciones descargar pdf (Pagina 31)

1 - 15

Scanner is Out of Range

The cordless scanner is always in communication with its base, even when it is

not transmitting bar code data. Whenever the scanner can’t communicate with

the base for a three second interval, it is out of range. If the trigger is pulled while

the scanner is out of range, the red LED illuminates on the IT3870 and the green

and yellow LEDs illuminate on the ST5770. When you scan a bar code, the

scanner issues 3 beeps and does not try to send data to the base.

Note: While the scanner is out of range, it consumes more power searching for

the base continuously. To conserve battery power, store the scanner with

the charge pack removed, or program it for Battery Conservation mode

(see page 2-15).

Scanner is Moved Back Into Range

The scanner silently rejoins (no beep after connecting and synchronizing with the

base) if the scanner has not been reset (charge pack disconnected and

reconnected), no menu codes have been scanned by other scanners in the work

group, and the base has not been reset (see Base Reset Conditions, next page).

Any one of these three conditions can cause the scanner to go through a

reassociation process (definition on page 1-16) when it is moved back in range.

If the scanner reassociates, you will hear a single beep when the reassociation

process (uploading of the parameter table) is complete.

If you believe you are in range and are still hearing a triple (error) beep, you may

have been removed from the base’s network. This could happen if the scanner

loses power or goes out of range for three seconds. Try scanning the association

label or reset the scanner by removing and reinserting the charge pack.

Replacing Charge Pack While Associated

When you insert the charge pack, the scanner beeps, followed by clicking.

During this period the work group parameter table is uploaded to the scanner

from the base. Scanning and data transmission is interrupted. When the

scanner emits a second beep, you may scan again. If you don’t receive a second

beep, the table was not transferred successfully either because the scanner was

out of range or all of the data was not received. Scan the association label again.

Moving Scanners From One Base to Another

You may transfer a scanner from one base to another simply by scanning a new

base association label. A scanner can only be associated to one base at a time.

Once a scanner has been associated to a base, it tries to stay associated to that

base until a new base association label has been scanned. The new base adds

a scanner to its association list as long as fewer than nine scanners are in its

network. If a base has nine scanners in its network, you need to disassociate

one scanner before adding another (see next section).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 199 200

Sin comentarios

Welch Allyn SCANTEAM 5770 LASER Especificaciones Pagina 31