Welch Allyn SCANTEAM 3470 CCD Especificaciones Pagina 12

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 108
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 11
Cordless Systems Manual
1–4
Cordless
Scanner
Charge the Battery Pack by following the steps shown below:
Rechargeable
Battery Pack
Plug the battery pack directly into
any common 120 Volt AC outlet.[
The LED on the bottom of the battery pack will
light red when the unit is charging; it shows
green when it is fully charged and ready to use.
To charge more than one battery pack
(or to charge the pack for all other
countries), use the Charge Strip.
After the battery pack is fully charged, attach it to the
Cordless Scanner by pressing the pack firmly (align
the prongs on the pack with the mating receptacles)
in the base of the scanner until the release buttons
click, holding the pack firmly in place.
(When you
attach a charged battery pack to the Cordless
Scanner, you will hear a single beep.)
If you haven’t set up your Cordless System, turn to the next page for
instructions.
Charging Your Battery Pack
[ Plug the battery pack into a wall socket in North America
only
. Failure to
comply could result in equipment failure.
When the battery pack needs recharging, the yellow LED on top of the scanner
pulses in short, continuous blinks and the scanner won’t beep when you pull the
trigger. If the LED stops flashing when the temperature lowers or you do not use
the battery pack for some time, you still need to charge the battery pack to avoid
damaging the battery pack or causing scanner memory loss.
Charge Time:
NiCad Battery Pack
8 hours at 120 VAC, 60 hz
4 hours at 220 VAC, 60 hz
5 hours at 220 VAC, 50 hz
NiHM Battery Pack
4 hours at any voltage and frequency
Vista de pagina 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 107 108

Comentarios a estos manuales

Sin comentarios